Watch this video and save yourself over $300!
👋 Welcome back to “Flix It Yourself” Tip 37! Today, we’ll tackle the common issue of moldy rubber seals on washing machine doors. Here’s a simple 5-step process to get rid of the mold:
Caution âš
This FIY should be done only by adults.
Make sure to use gloves mask and eye protection.
Make sure the bleach, etc. doesn’t get onto any clothes.
â¿¡ Clean the rubber seal with a bleach-based cleaner. Use a good scrubber to reach all corners.
â¿¢ After cleaning, spray bleach again over the entire seal and sprinkle pool shock. Make sure to cover all corners.
â¿£ Let it sit for 30 minutes, then clean off as much of the pool shock as possible with a wet rag.
⿤ Turn on the machine and run a load on the sanitize or cleaning mode.
⿥ Open the door and witness the magic! 🎉
• To prevent the mold from happening again, purchase the magnetic stick that will hold the door open when it’s not in use.
• Remember to clean the machine once a month with a cleaning pod to reach those unreachable places.
For the products mentioned in the video:
🔹 Pool Care Shock: https://amzn.to/43K6VD8
🔹 Amazer Dish Brush with Handle: https://amzn.to/4ae9xLR
🔹 Clorox Cleaner with Bleach: https://amzn.to/4cHNVcf
🔹 Magnetic Stick to hold the door open: https://amzn.to/49iouLA
🔹 Washing Machine Cleaner: https://amzn.to/3xqmbsq
If you enjoyed our video, please leave us a nice 5-star review! 😊
https://g.page/r/CVvo19wIleurEBE/review
Have a wonderful week.
Affiliate Disclaimer: The products showcased here are associated with Amazon, and we may earn a commission for qualifying purchases. We want to be transparent with our audience and appreciate your support.
#howto #diy #cleaningtips #molds
